Help needed with cutter guide

[Fries With That]

Hi Guys, I'm in need of some help creating a cutter guide to make the attached box when closed. I need there to be a flat triangular edge in the top left corner. I've tried mocking up but am finding it quite a struggle!

All help appreciated

Thanks

Dan

[simon@designviaproxy]

Hi mate - Without knowing how the box opens for use it's tricky to give accurate advice. Does the top edge have a void i.e. no actual panel? If so then it is tricky to make out of cardboard. Is the chamfered triangle corner essential? You could vacuum form it out of plastic quite easily, just make a wooden template first but you do need someone with a vacuum former obviously.

If all sides of the box are solid, then the triangle would be best hard attached to the top side of the box with two tabs on the other two edges. Cut out the exact angle from the two vertical panels. If this IS the way you are doing it, then carefully open up a cereal box along it's tabbed join and you will see how to attach each side into a net.

A bit more input is needed from you before complete advice can be given!

[Katedesign]

I would make it part of the lid...front left hand (looking at it face on) - I think. Would have to play with a net to get it right - try drawing it up and cutting it out of some light card.

[bigdave]

I'd imagine it'd be somewhere along these lines:

[Katedesign]

I would try a box more like this...

but you will have to fiddle it!

[Fries With That]

Hi all, many thanks for all of your replies, sorry it's taken so long to get back on here!

Much appreciated.

Dan